Alta Striping Equipment – ATA 400 Highlights

 

1.     25 HP EFI – 2015 EPA/CARB approved Propane Engine:EFI (electronically fuel injected) allows for ease of quick starting, as most propane engines will crank for some time before firing.

2.    30 AMP charge system with 650 CAA Battery.

3.    Engine controls located at operators position: For ease of operation at operators position. 

4.     Electronic Proportional Throttle With Cruise Control: No mechanical connection to the hydrostatic drive pump with programing capability to adjust for operator.

5.    Hydraulic wheel motors with internal hydraulic brakes: For a positive brake system that will not release due to mechanical linkage and also needs no adjustment. Manual brake release for towing.

6.    39" Wheel Track and 44" Wheel Base for low center of gravity and stability: Keeps unit from tipping side to side which helps in maintaining consistent line widths.   

7.    "Skipline, Inc." Skiptimer system with: Footage Counters and Speedometer. Three separate pattern selections that can be changed on the fly. USB port for software upgrades. Support from a well establish company.    

8.    Double Drop bead system with pattern selector switch.    

9.    AMSE Air tank.    

 

 

10.    Manifold mounted air solenoid valves for ease of service: 4 way and 3 way valves use same manifold.

11.     Pressure compensated hydraulic pump to drive material pump and hot oil circulation pump: Allows for consistent none varying speeds at the material pump and hot oil pump. (Speeds not affected by engine RPM)

12.     Electronic Proportional dual material speed control: Dial control knobs located at operators position to allow for change in material application rates. Adjustable dual pump control allows for automatic pump speed step up when second gun is activated.

13.   Easy access to hot oil pump. Hydraulic driven to maintain consistent speed for longer pump life. Not belt driven.   

14.    400 LB. material kettle, propane fired.

15.    8.5 CFM @ 110PSI air compressor

16.     4" – 8" – 12" combo ribbon applicator shoe with bayonets for 4" – 4" – 4" and 6".  

17.    Powder coated finish for ease of clean up and longevity